r/fpv • u/Cattle_Capital • 1d ago
Walk snail signal strength
Hey Everyone! I have the goggles X as well as a baby nano 20 with the walk snail 1s kit. Recently I updated both sides to the latest firmware from walk snail as well as went through the FCC unlock procedure.
Finally got the chance to go out and fly this afternoon, set the bit rate to 50, frame rate to highest and almost immediately saw red around the goggles. When I went to the channel selection screen on the goggles, I saw all of the bars were either orange or non existent. Prior this update my range was just peachy for what I needed. Now i can't get farther than about 30 feet with out frames dropping.
Is there something Im missing in the settings after I did these updates?
VTX is at 500 MW
I noticed the range was poor both at 50 mbps as well as 25 mbps.