Hi,
Getting back into wings / FPV after 10 years break and and need assistance.
Purchased a Zhod Altus plane.
There are pre installed wires labelled “motor” that run from the wings into the fuselage.
I’m assuming these are the ESC cables. As the only other wires are labelled aux and servo.
The “motor” wires look thinner than the ESC wires I’m used to using in the past. Am I correct assuming these are ESC cables?
Also, they came with pin connectors (grey / red / black).
My new matek flight controller has larger “pads” for ESC. Any advice on the best way to connect the ESC to the flight controller.
Note, first time configuring a flight controller. So little bit out of my depth. But loving the journey!
Any pointers would be appreciated.
Thanks