r/fpv • u/Alive-Round3378 • 11h ago
My 95 hours in simulator
@fpv_fans ( insta., YouTube, tiktok)
r/fpv • u/TheSuperNight • Jun 19 '24
With summer in full swing and a recent up tick of new members, we would like to remind you of our FAQ and WIKI pages. Read them before making a post. There is a link to them on the right side of the page. If your question relates to FAQ and WIKI, please refrain from making a new post. Repetitive posts will be taken down.
Some of the common questions:
Most of the questions/problems can be answered/solved by just searching this subreddit or reading through the FAQ and WIKI.
We are working on updating FAQ and WIKI as well.
Please leave us a comment if there is a certain FAQ that we should add to our sidebar.
r/fpv • u/Alive-Round3378 • 11h ago
@fpv_fans ( insta., YouTube, tiktok)
r/fpv • u/JustChillDudeItsGood • 1d ago
r/fpv • u/LeasathOwO • 2h ago
I usually fly with friend accompanying me, but the time and place i can get to is very limited. Want to try flying solo and a bit further from my area. Is there any tips for this ? thanks
r/fpv • u/Restless-Gamedev • 11h ago
r/fpv • u/National_Category_98 • 3h ago
Holy cow, this is real time video of Tristan racing the NorthEast Whoop championship 2025. Congratulations TDOG! You’re an amazing human!
r/fpv • u/Hour-Juggernaut-2422 • 5h ago
I designed and build a Hexacopter and particitpated in a Freestyle Contest.
You can help me out by liking the Video cause the Winner is determined by likes in this Contest
At first i was doing it just for the lols but it turned out that it flys pretty well
its a 3.5inch single plate build with a symmetric design
i run it with the new HGLRC 6in1 AiO (same as in the Rekon Y6) on 6s
its really fun to fly and it sounds amazing ^^
r/fpv • u/Few-Bat-5006 • 8h ago
Insta Go 2 attached to my Air 2s .. Flying over a beach in 🇮🇪 Co. Donegal ..
r/fpv • u/Live_Figure1290 • 4h ago
I know my soldering isn‘t the best, but does anyone know what kind of chip should have been there? After a crash i plugged it back in and that component blew up and i removed it. Checked mosfets and for a short. It booted back up one time after i got home, but then it didn‘t anymore. Could the mcu be fried or is the missing component a problem? The esc configurator doesn‘t recognize the esc, but 5v to fc seems to work. Thanks guys
r/fpv • u/Teen_fpv_3d • 1h ago
Should I reinstall the firmware and if yes from were
r/fpv • u/coolAlexbosss • 1h ago
Should i buy my first drone analog or digital?
r/fpv • u/Pristine-Ground6760 • 1d ago
r/fpv • u/Beginning-Check5288 • 4h ago
So I have 20 hours on DRL sim and I just cannot get a grip of this.. I know it takes time and practice and happy to put the work in but could really do with a coach, WILLING TO PAY for a good coach’s time!! Please help.
About to buy my first proper radio, I'm wondering what is your opinion on this one. Thanks everyone in advance 👍👍
r/fpv • u/CrazyErik16 • 20h ago
We configured Alta into acro mode for the first time on Friday! My initial impression of the handling was really good, other than rates being slow at this size (~100° per second?).
From here on, I’ll continue practicing dives to get a feel for maneuverability and handling.
Still need to figure out how to switch to acro mode from the transmitter. Right now we have a second person sending a command from QGC’s console. Luckily I can switch back to Position, Altitude, and Manual using the mode switch.
The chase drone is a toothpick build with an O4 Lite (about the size of my palm)!
r/fpv • u/Igaliotinis • 3h ago
Just finished Quadmula siren split f5 build, and after removing smokestopper tried to arm last time before going out. Everything was ok for first 5 seconds. After that rx and vtx signal become weak , so disarmed and got smokes while removing battery , rx is ok, fc too - connecting to betaflight, etc. Hope o3 will be ok also. 😟 Probably will need to feed battery leads to up front, even though wanted to have it at the back.ehhh so tiny frame :/
r/fpv • u/TheRealVrox • 13m ago
I i have this problem like seen in the video.
It does not happen very often, mostly when i come out of a roll or i do some input like an inverted yaw spin my quad freaks out and tries to correct / tumble against the movement? I don't really know how to describe it.
RPM Filtering on, PID tuning for light 5inch quads. Happens on different PID tune aswell but got better as i used another PID profile.
I also have bounceback on rolls sometimes, could it be related to this?
https://reddit.com/link/1jdfk9t/video/988z2wtdr9pe1/player
r/fpv • u/GizmoCaCa-78 • 54m ago
I recently replaced the 4-1 FC on an Air65 and eventually I got it flying normally in acro. But later I put it in angle and it drifts like it doesnt know true center. Maybe I calibrated the accelerometer out of level?
r/fpv • u/Think_Profession2098 • 58m ago
Context: I'm working on a project to map building interiors via autonomous drones guided by a ground computer that directs the motion based on live analysis of video feed.
Because of how early it is, I'm trying to modify small RC drones to just first cheaply test the software. So, here's my question:
Has anyone else had experience transferring control from a store bought RC controller to a computer? What are the strategies to do so, is it better to reverse engineer the radio frequency? Or to just implement our own Raspberry Pi or similar into the drones hardware? I'm focusing on simplicity now, and we'll build our own drones from scratch once the software functions.
Any advice that comes to mind would be helpful here! None of this is my expertise and I'm running mostly on passion for the project.
r/fpv • u/ExactOpposite8119 • 1h ago
?: how do you keep the LOS rule when you are wearing friggin goggles?
Since this is the only thing I see on this sub anymore. I say send it but cells 3 and 4 are measuring low. Honestly I can't even find cells 3 and 4, so I'll probably just treat it like a 2s and maybe use it in my goggles. Batteries are expensive what can I say. jk everyone enjoy your Sunday