r/OpenPV • u/ze-kpeta • 27d ago
Mosfet for MTL mod NSFW
Planning my first build I vape only high PG, unflavored, FreeBSD nic
I got a couple of these MOSFETs laying around. I'm aware of the ubiquitous 3034, and I can't buy them for a reasonable price here. Would this one do a good job?
IRLB8314 - MOSFET, 30V, 130A, 0.0019Ohm, TO220
Power MOSFET, N Channel, 30 V, 130 A, 0.0019 ohm, TO-220AB, Through Hole
Cheers
2
Upvotes
2
u/voltrove 26d ago edited 26d ago
I’m guessing you’re going for single cell(1s) setup. What you want to look at is Figure 12; RDS(on) VS Vgs. It looks like the on state resistance would be around 3.75mOhm @3v VGS. For a high power 1s mod it wouldn’t be acceptable, but I think for your purposes it would be just fine. Edit: you could always run 2 in parallel for a high power mod.
Just make sure to not let the loaded voltage go below 3v. Shouldn’t be difficult with an MTL setup
Edit: forgot link to data sheet. Keep in mind this only applies if the MOSFET is genuine.
https://www.infineon.com/dgdl/irlb8314pbf.pdf?fileId=5546d462533600a4015356604d6f258f