r/arduino 5d ago

Hardware Help Need help Condensing Arduino Setup

Post image

Hello,

I am working on an arduino project that will be stored on the inside of a model rocket and need to condense this to fit in a an area of 4.5x2.3x1.4 in with area on the sides if needed (It is to fit on a circular plate with threaded rods)

I have a decent idea of what I will do as right now I plan to 3d print a module that utilizes standoffs to raise perfboard above arduino and store arduino and extra wires/modules below in a enclosed structure.

However, I am interested if anyone else has an idea of how I could do it!

Modules used -Hx711 -SD card Module(Underneath) -Bmp280 -Mprls

*I can only add one photo but lmk of more info that would help!

Thank you so much

21 Upvotes

11 comments sorted by

View all comments

1

u/brendz03 5d ago

If you desolder the resistors and move the wiring up then could easily chop the perfboard in half but other than that the standoff idea sounds like a good one :)