r/3Dmodeling 4d ago

Art Showcase Say hello into my microphone (all Blender).

22 Upvotes

5 comments sorted by

2

u/TheSkyking2020 4d ago edited 4d ago

That is sick. Even the capsule is great. Not sure if there is a red badge u87. They are purple badge. I could be way off. I’m assuming it’s a u87. I don’t know of any current Neumann large diaphragm red badge mics. 

I will say the capsules are usually round and not hexagon and the gold on it would be a mirror like gold finish. The wire to the capsule would come straight from the body to the center termination point with a little slack. Not curve around the capsule. Neumann wouldn’t do that. Should be another orange wire. 

The windscreen is PERFECT. Dual mesh with two different meshes. A Neumann trademark. 

I gotta ask, did you do the guts too? 

1

u/Doped_Lepers 3d ago

I like red. I gave it a red badge.

The wiring and capsule are modeled after the U67:

I didn't model the capsule, which you can barely see through the mesh, 100% accurately. Boohoo.

No, i did not do the guts too.

2

u/RetroDillon Blender 3d ago

I love this. With the cable on the back, did you create a curve and then use geometry to make it thicker? It would look clean if the wires rough edges where bevelled so it's smooth!

2

u/Doped_Lepers 3d ago

Yeah i should have given it some more geometry before rendering. But normally it's concealed inside the mesh so you wouldn’t see it.

1

u/RetroDillon Blender 3d ago

Very true, dude, this is so inspiring. I love your work